Hot Bonder Composite Repair

Self-contained, portable hot bonder repair systems offer safety and reliability. For large or small repairs the ACR-II portable hot-bonder offers unparalleled ease of use. Only properly rated power (90v - 264v) will enable the ACR-II hot bonder to boot up and supply the appropriate heat. Thermocouples provide temperature input, maintaining the correct temperature for the entire repair cycle.

Cure cycles or recipes can be written in the field or on any PC with a USB 2.0 port and Hot Bonder Recipe Data Editor software. A touch screen interface allows the operator to enter and change any parameter on the program screen.

Able to perform in the tightest of spaces, the safety, durability and reliability of the ACR-II portable hot bonder performs well on big and small jobs.

ACR-II Hot Bonder Features

• Controls the heat and vacuum for on-the-spot composite and metal bond repairs
• Single or dual zone models
• Portable, easy-to-carry case holds your heat curing blankets, vacuum hoses, and accessories
• Accepts either standard or mini J-type thermocouple connectors
• 10 thermocouple sensors per zone
• Universal voltage: 100-130VAC, 200-240VAC
• 1400°F (760°C) maximum temperature control
• Built-in vacuum pump and vacuum venturi models available
• Models designed for hazardous / flight line environments
• Programmable to either standard or metric units
• Cure recipes can be edited on hot bonder or on included BriskHeat® Recipe Data Editor for Windows® software
• Pre-programmed with English and German languages
• 73/23/EC (low voltage directive) and 89/336/EC (EMC directive) for part number ACR-IIN1E30

ACR-II Hot Bonder Specifications

General

• USB port for data transfer (USB flash disk included)
• Input ground fault interrupter breaker protected
• Audible and visual alarms for high and low temperature / vacuum limits
• Digital data logger: prints and records real-time status of cure including program parameters (printer not included with models designed for hazardous / flight line environments)

Power

• Input Voltage: 100-130VAC, 200-240VAC
• MAINS supply voltage fluctuations up to ±10% of the nominal voltage
• Transient over voltages typically found on a Category II power source: i.e. a lighting circuit
• Frequency: 50-60Hz
• 30 amps maximum per zone
• Output cord receptacle: NEMA L14-30R

Vacuum

• Pressure: 27-28in Hg (13.26-13.75PSI)
• Flow:
• 5.7 scfm (Vacuum Venturi)
• 0.9 scfm (Vacuum Pump) Ability to manually adjust pressure for each zone

Temperature Control

• Cure up to 1400°F (760°C)
• 10 thermocouple sensor inputs per zone
• Accepts either standard or mini type J thermocouple connectors

Environment

• Intended for use in dry environments. Do not expose to spray.
• Altitude up to 6562ft (2000m)
• Storage temperature range: -4 to 140°F (-20 to 60°C)
• Operating temperature range: 41 to 104°F (5 to 40°C)
• Maximum relative humidity: 80% for temperatures up to 88°F (31°C) decreasing linearly to 50% relative to humidity at 104°F (40°C)
• Pollution degree 2 (normally only non-conductive pollution occurs, however a temporary conductivity caused by condensation must be expected)